Velocity Edge GX440 User's Guide Page 74

  • Download
  • Add to my manuals
  • Print
  • Page
    / 412
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 73
ALEOS 4.3.4 Software Configuration User Guide
74 4114514
2. When using a specific interface, the AirLink device acts as a DHCP server
unless disabled. When the Host Connection Mode is Ethernet Uses Public IP,
and the AirLink device receives a DHCP request from an Ethernet device
connected to its ports, it hands off the assigned address to the device and
sets up the default gateway address as 10.1.2.1. If the fourth octet value is
already a 1, it assigns 10.1.2.2 as the router address.
Note: The primary gateway to the cellular network, for any connected device, is enabled
by default.
3. The AirLink device also sends a /24 netmask (255.255.255.0 by default) and
sets up a static route which maps 192.168.13.31 (or the address configured
with *HOSTPEERIP if it is changed) to 10.1.2.1 (or 10.1.2.2 if that was what
the gateway address was given as).
Tip: When PPPoE is used with the AirLink device, the DHCP server needs to be disabled.
A tunnel is set up connecting a device (such as your computer or a router) with the AirLink
device. The device then uses the MAC address of the AirLink device to send all outgoing
packets.
Ethernet
The AirLink device is equipped with an Ethernet port that can be enabled or
disabled as needed. When the port is disabled, the host cannot connect via
Ethernet, and ARP queries do not receive responses on the port.
Figure 4-5: ACEmanager: LAN > Ethernet
Page view 73
1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 411 412

Comments to this Manuals

No comments