Velocity Edge GX440 User's Guide download pdf (Page 208)

ALEOS 4.3.4 Software Configuration User Guide

208 4114514

2. After deployment, the device begins measuring a physical input.

3. The measurement is compared to the user-configured threshold or state

change. If there is no change, then another measurement is performed. If a

state change (or threshold crossing) occurs, then the flow moves to step 4.

4. The Action associated with the Event. In this step, a report may be generated,

or some other activity is performed. Afterwards, the flow returns to step 1.

Additional Behavior and Features

Events/Actions are not one shot activities. After an Action is performed, the Event

is still active and will trigger the next time the state change or threshold crossing

occurs.

A single Event may activate one or more Actions. For example, if RSSI is below

threshold, you can turn off data services (Action 1) and send an SMS message

(Action 2).

A single Action may be activated by one or more Events. For example, if the

vehicle speed is above a threshold or if the vehicle heading changes, either Event

can perform the same action.

After defining an Event, always select the Apply button to save these definitions

and apply them to an Action.

Selecting the Delete button on the Events Reporting tab will delete all current

Event and Action data.

Configuration Overview

To configure Events and Actions, complete the following steps:

Note: All Events Reporting configuration changes take effect after a short delay (about one

minute). No reboot of the AirLink device is necessary.

1. Define an Event – Events can be configured using the ACEmanager user

interface. Select the Events Reporting Tab, and then select the Add New

subtab to add an event (e.g., RSSI).

Note in the Action Description frame that there are no actions listed.

1 2 ... 203 204 205 206 207 208 209 210 211 212 213 ... 411 412

No comments

Velocity Edge GX440 User's Guide Page 208