Serial Configuration
Rev 1 Oct.13 241
UDP Settings
Figure 11-10: ACEmanager: Serial > IO X-Card Serial Port > UDP
Table 11-9: Serial > IO X-Card Serial Port > UDP
Field Description
UDP Auto Answer Whether the AirLink device auto answers an incoming UDP connection request
Options are:
• Enable
• Disable (default)
You can also use an AT command to configure this field. See S82 on page 364.
UDP Idle Timeout
(seconds)
UDP idle time-out in seconds
Specifies a time interval upon which if there is no in or outbound traffic through a UDP
connection, the connection is terminated.
You can also use an AT command to configure this field. See S83 on page 365.
UDP Connect Last Allows you to choose to use the last accepted IP address and port number as the
default settings, instead of using S53 (destination address)
Options are:
• Do not change S53 — Does not change the destination IP address (default)
• Set S53 as last —Uses the last accepted IP address
Note: Resetting the device restores the configured S53 (destination address).
You can also use an AT command to configure this field. See *UDPLAST on page 365.
Comments to this Manuals