Rev 1 Oct.13 335
*DNS1?
*DNS2?
Query the primary DNS (*DNS1) and secondary (*DNS2) IP addresses.
AT*DNS1? to query DNS1
AT*DNS2? to query DNS2
*DNSUSER Query or set the first alternate server for DNS override. (Applies only to primary DNS.)
AT*DNSUSER? to query
AT*DNSUSER=d.d.d.d
• d.d.d.d=IP address of domain server
*HOSTAUTH Query or set the Host Authentication mode for PPPoE only. (It does not set host
authentication for PPP/DUN.)
AT*HOSTAUTH? to query
AT*HOSTAUTH=n to set
• n=0—None/Disables authentication for PPPoE (Default).
• n=1— Authentication through PAP
• n=2—Authentication through PAP & CHAP
*HOSTPEERIP Query or set the IP address of the device’s Ethernet port. By default this is 192.168.13.31.
Note: Any connected LAN host can access this IP addresses, whether using a private or
public IP address. This IP address must be in the same subnet as the Ethernet DHCP pool.
AT*HOSTPEERIP? to query
AT*HOSTPEERIP=d.d.d.d to set
• d.d.d.d=local or peer IP address of the device
*HOSTPRIVIP Query or set the starting IP for the Ethernet DHCP pool.
AT*HOSTPRIVIP? to query
AT*HOSTPRIVIP=d.d.d.d to set
• d.d.d.d=IP Address
*HOSTPRIVMODE Query or set the host communication mode used for tethered IP connections.
AT*HOSTPRIVMODE? to query
AT*HOSTPRIMODE=n to set which user interface uses the Public IP address
• n=0—Ethernet Uses Public IP
• n=1—All Hosts Use Private IPs
• n=2—USB Uses Public IP
• n=3—DUN Uses Public IP
• n=4—First Host gets Public IP
*HOSTPW Query or set the host password for PPPoE only. (It does not set the password for PPP/
DUN.)
AT*HOSTPW? to query
AT*HOSTPW=PASSWORD to set
Note: PASSWORD cannot be “password”.
Table D-4: LAN AT Commands (Continued)
Command Description
Comments to this Manuals