ALEOS 4.3.4 Software Configuration User Guide
346 4114514
PTMR Query or set the Low Power Mode Delay (in minutes) This is the delay between the
time the power down trigger occurs and when the device enters the low power
mode.
ATPTMR? to query
ATPTMR=n to set
• n=0–255 (minutes)
Note: There is always a minimum of 1 minute between power down event and
actual shutdown (to give the device time to prepare); entering zero will not power
down the device immediately.
VLTG Query or set the voltage level (threshold for low power mode). When the power
drops below this level Low Power Mode is triggered.
ATVLTG? to query
ATVLTG=n to set
• n= 0—Ignore voltage for power control
• n= 80–360—threshhold in .1 volt units
Example: ATVLTG=130 would place the device in a low power use, standby state if
the voltage goes below 13.0V.
Dynamic DNS
*DOMAIN Query or set the domain name used for the IP Manager Dynamic DNS
configuration.
AT*DOMAIN? to query
AT*DOMAIN=DOMAIN to set (up to 20 characters)
Example: AT*DOMAIN=eairlink.com
Tip: Only letters, numbers, hyphens, and periods can be used in a domain name.
Note: This AT command is only usable if the Dynamic DNS Service type is set to IP
Manager.
*DYNDNS Query or set the Dynamic DNS Service type to use.
AT*DYNDNS? to query
AT*DNYDNS=n to set
• n=0—Disable (default)
• n=2—dyndns.org
• n=5—noip.org
•n=6—ods.org
• n=8—regfish.com
•n=9—tzo.org
• n=10—IP Manager
Note: Only IP Manager can be fully configured using AT Commands.
Table D-8: Services AT Commands
Command Description
Comments to this Manuals