ALEOS 4.3.4 Software Configuration User Guide
370 4114514
S23 Configure Serial Port
ATS23? to query
ATS23=[speed],[data bits][parity][stop bits] to set
Speed:
• 300
• 1200
• 2400
• 4800
• 9600
• 19200
• 38400
• 57600
• 115200
Data bits:
•7
•8
Parity:
•O=Odd
• E=Even
• N=None
•M=Mark
Stop bits:
•1
•1.5
•2
Example:
ATS23=115200,8N1 (Sets the device to 115200, etc.)
The settings take effect after reset.
Note: Must be 8 data bits for PPP mode.
S211 For applications or situations where hardware control of the DTR signal is not possible, the
device can be configured to ignore DTR. When Ignore DTR is enabled, the device operates
as if the DTR signal is always asserted.
ATS211? to query
ATS211=n to set
• n=0—Use hardware DTR (default)
• n=1—Ignore DTR
• n=3—Ignore DTR and assert DSR.
S221 Query or set the Connect Delay—the number of seconds to delay the connect response
when establishing a TCP connection.
ATS211? to query
ATS211=n to set
•n=0–255
Table D-11: Standard (Hayes) AT Commands (Continued)
Command Description
Comments to this Manuals