Velocity Edge GX440 User's Guide Page 238
- Page / 249
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
ALEOS 4.2.3 User Guide
238 20080616
Low Power
Firewall
Table E-16: Common: Low Power
Command Description
VLTG Set or query the voltage level at which the device goes into low power mode.
• n=0 : Ignore voltage for power control.
• n=threshhold in tenths of volts
Example: ATVLTG=130 would place the device in a low power use, standby
state if the voltage goes below 13.0V.
PTMR Number of minutes after the VTLG power down event happens until the
device enters the low power mode. If VLTG is 0 (zero), this setting does
nothing.
• n=0-255 minutes
Note: There is always a minimum of 1 minute between power down event
and actual shutdown (to give the device time to prepare); entering zero will
not power down the device immediately.
SISE Standby Ignition Sense Enable: the device will monitor the ignition sense on
the power connector and enter the low power consumption stand-by mode
when the ignition is turned-off.
• n=0 : Disable
• n=1 : Enable
Table E-17: Common: Firewall
Command Description
FM Firewall mode - Only allow specified IPs to access the device.
• n=0 : Disable Firewall mode
• n=1 : Enable Firewall mode - Only packets from friends will be accepted,
packets from other IP addresses are ignored.
FO (F1, F2, ... F9) Friends List IP address.
• n=0-9 Friends list index
• d.d.d.d = IP address
Using 255 in the IP address will allow any number.
Example: 166.129.2.255 allows access by all IPs in the range 166.129.2.0-
166.129.2.255.
- ALEOS 4.2.3 Configuration 1
- User Guide 1
- Trademarks AirCard 4
- Contact 4
- Information 4
- Revision 5
- 6 20080616 6
- Rev 2.3 Feb.12 8 8
- Rev 2.3 Feb.12 9 9
- ALEOS 4.2.3 User Guide 10
- 10 20080616 10
- Contents 11
- Rev 2.3 Feb.12 11 11
- 12 20080616 12
- Rev 2.3 Feb.12 13 13
- 14 20080616 14
- 1: Introduction 15
- 16 20080616 16
- Tools and Reference Documents 17
- 18 20080616 18
- Main Menu Tabs 20
- Configuring 20
- Operation Modes 20
- Telnet/SSH Mode 22
- Creating a Template 23
- Applying a Template 24
- 26 20080616 26
- 3: Status 27
- 28 20080616 28
- WAN/Cellular 29
- 30 20080616 30
- Rev 2.3 Feb.12 31 31
- 32 20080616 32
- Rev 2.3 Feb.12 33 33
- VPN connection has been made 33
- Security 34
- Services 35
- 36 20080616 36
- Applications 38
- Rev 2.3 Feb.12 39 39
- 40 20080616 40
- 4: WAN/Cellular Configuration 41
- 42 20080616 42
- Keepalive 47
- Data Usage Using Keepalive 47
- Re-Activation 48
- 5: LAN Configuration 49
- DHCP/Addressing 50
- LAN Configuration 51
- Rev 2.3 Feb.12 51 51
- Internal DHCP Server 52
- Ethernet 53
- Virtual Ethernet 57
- Virtual Serial 59
- Host Port Routing 62
- Global DNS 63
- 66 20080616 66
- 68 20080616 68
- 6: VPN Configuration 69
- Split Tunnel 70
- VPN Configuration 75
- Rev 2.3 Feb.12 75 75
- SSL Tunnel 76
- Rev 2.3 Feb.12 77 77
- L2TP+IPsec 78
- VPN 2 to VPN 5 82
- 7: Security Configuration 83
- Port Forwarding and DMZ 84
- Port Filtering - Inbound 86
- Port Filtering - Outbound 87
- Trusted IPs - Outbound 89
- MAC Filtering 90
- Packet Inspection 91
- 92 20080616 92
- 8: Services Configuration 93
- ACEmanager 94
- 96 20080616 96
- Configuring Engine Hours 98
- Dynamic DNS 99
- Third Party Services 100
- IP Manager 101
- Understanding Domain Names 102
- Dynamic Names 103
- Control Only 105
- 106 20080616 106
- Gateway Only 107
- Control and Gateway 108
- Trusted Phone Number 111
- Telnet/SSH 112
- Email (SMTP) 113
- Management (SNMP) 114
- Services Configuration 115
- Rev 2.3 Feb.12 115 115
- 116 20080616 116
- • SNMP is disabled 116
- • 65535 116
- Time (SNTP) 117
- 118 20080616 118
- 9: GPS Configuration 119
- Remote Access Protocol (RAP) 120
- Before Configuring GPS 121
- Server 1 122
- Redundant Server 125
- Server 2 to Server 4 126
- Reliability Modes 127
- Local/Streaming 128
- Global Settings 130
- 132 20080616 132
- Introduction 133
- Configuration Overview 135
- Action Description 137
- 138 20080616 138
- Email/SMS 140
- Report Groups 141
- Configure Events 143
- 144 20080616 144
- 11: Serial Configuration 145
- 146 20080616 146
- MODBUS Address List 151
- 152 20080616 152
- 12: Application Configuration 153
- 154 20080616 154
- 13: I/O Configuration 161
- Pulse Count 162
- 14: Admin 163
- Advanced 164
- Radio Passthru 165
- A: Modbus/BSAP Configuration 169
- Modbus TCP/IP 170
- Modbus on UDP 170
- Host for Modbus on UDP 171
- Modbus with UDP 172
- 174 20080616 174
- B: PPP over Ethernet (PPPoE) 175
- Figure B-10: PPPoE Connection 179
- 180 20080616 180
- Figure B-14: PPPoE Connection 181
- 182 20080616 182
- Protocol 183
- SYNTAX DisplayString 188
- 204 20080616 204
- GPS Overview 205
- Configuring the Datum 208
- Over-The-Air (Remote) Host 208
- Local Host 209
- TCP GPS Report Polling 209
- Report Types 209
- Sending Reports Automatically 210
- Store and Forward 210
- RAP Configuration 212
- Device ID 213
- Odometer Data in Reports 213
- I/O Event Reports 214
- NMEA Configuration 215
- Streaming Messages (Local) 216
- TAIP Emulation Configuration 217
- Local Connection 218
- 220 20080616 220
- E: AT Commands 221
- CDMA Info 223
- CPU Status 224
- ATS53=T192.168.100.23/12345 225
- ATS53=foo.earlink.com 225
- ATS53=192.168.100.23/12345 225
- ATS53=/12345 225
- Dynamic IP 232
- PPP/Ethernet 233
- PassThru 234
- Low Power 238
- Firewall 238
- Serial Port 244
- 248 20080616 248
Related products and manuals for PC/workstation barebones Velocity Edge GX440
(127 pages)
(79 pages)© 2020, manymanuals.com. All rights reserved. | 0.508 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals