Velocity Edge GX440 User's Guide Page 209

  • Download
  • Add to my manuals
  • Print
  • Page
    / 249
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 208
Global Positioning System (GPS)
Rev 2.3 Feb.12 209
Local Host
To set the AirLink device to report to a local host, one directly connected to the
serial port, configure the port to be used with S53 - Destination Port. The local IP
address will automatically be used for local reports. S53, in ACEmanager, is part
of the GPS group.
If you need to send reports to additional local ports, you can specify other ports
with *PPLATSEXTRA. Local Reports can be sent to up to 7 additional ports
consecutively following the S53 port. If S53=1000 and *PPLATSEXTRA=4,
reports will be sent to 1000, 1001, 1002, 1003, and 1004. In PPLATSEXTRA,
specify the number of ports where you want the reports sent, 0 to 7 (0 disables
extra ports).
TCP GPS Report Polling
The AirLink device can easily and quickly be polled for location by opening a TCP
connection to port 9494 (default). Once the connection is established, the AirLink
device will send a report with the current position using the GPS report type the
modem is configured to use.
You can change the port for the TCP GPS poll using *PPTCPPOLL.
Note: Some Internet providers (including cellular) block ports below 1024.
Report Types
There are several report types available. For remote reports, set *PPGPSR. For
local reports, set *PPLATSR.
•0 - *MF, Legacy reports for use with ATS version 4 and older.
•11 - Global Positioning System (GPS) data.
•12 - GPS data with the UTC time and date.
•13 - GPS with time and date and Radio Frequency data from the antenna.
•D0 - Xora reports.
•E0 - NMEA GGA and VTG sentences.
•E1 - NMEA GGA, RMC, and VTG sentences.
•F0 - TAIP data
•F1 - TAIP compact data
Tip: The AirLink device can be configured to supply one type of report to a remote host
and a different report type locally through the serial port at same time. However, there may
be conflicts due to the local and remote reporting being in different modes and not all
features to both modes may be available.
Page view 208
1 2 ... 204 205 206 207 208 209 210 211 212 213 214 ... 248 249

Comments to this Manuals

No comments