Rev 2.3 Feb.12 223
CDMA Info
*NETSTATE? The current network state:
• Connecting To Network: The device is in the process of trying to connect
to the cellular network.
• Network Authentication Fail: Authentication to the cellular network has
failed. Verify settings to activate the device.
Data Connection Failed: The device failed to connect, and it is now waiting a
set time interval before it attempts to reconnect. Verify settings to activate the
device.
• Network Negotiation Fail: Network connection negotiation failed. This is
usually temporary and often clears up during a subsequent attempt.
• Network Ready: The device is connected to the 1x cellular network and
ready to send data.
• Network Dormant: The MP is connected to the 1x cellular network, but
the link is dormant. It will be woken up when data is sent or received.
• No Service: There is no cellular network detected.
• Hardware Reset: The internal module is being reset. This is a temporary
state.
*NETCHAN? The current active CDMA channel number.
*HOSTMODE? The current host mode (AT, PPP, UDP, etc.). If the device is not in AT mode,
telnet into the device to execute this command.
*NETERR? The EVDO or CDMA network frame error rate.
The network frame for CDMA or EV-DO.
*NETSERV? The type of service being used by the device, e.g., Tech EV-DO Rev A.
Table E-2: Status: Network (Continued)
Command Description
Table E-3: Status: CDMA Info
Command Description
+PRL Preferred Roaming List (PRL) version.
*PRLSTATUS The status of the most recent PRL Update.
• 0 : None
• 1 : In Progress
• 2 : Success
• Any other value: Failure.
CDMA ECIO Indicates the signal-to-noise ratio, i.e., the quality of the signal.
Comments to this Manuals