Velocity Edge GX440 Specifications download pdf (Page 107)

Command Reference

Rev 3.2 Oct.05 105

6 Length of pause before dialing (ignore dial tone)

This register denotes the wait time (between 2 and 10 seconds)

before a blind dial, with no dial tone detection. The default value

is <n>=2 seconds.

The value of ATS6 is used when the ATX command is set to 1

or 3. ATX settings of 2 and 4 enable dial tone detection and

disable blind dialing. Therefore, when X is set to 2 or 4, the

value of S6 is ignored.

0–255 002 seconds

7 Wait time for connection

This register sets the limit, between 1 and 255 seconds, for how

long the modem will wait for a carrier signal from a remote

modem before hanging up. The default value is <n>=50

seconds.

1–255 060 seconds

8 Length of comma pause

This command is provided for compatibility reasons; no action

is taken by the modem. Parameters are ignored.

0–255 002 seconds

10 Carrier detection and carrier loss delay

Specifies how long the carrier from a remote modem can be

absent before the modem disconnects (between 0 and 255

seconds). Longer delays allow temporary disruptions to the

carrier without disconnecting. Shorter delays detect dropped

carriers more efficiently when the connection is good.

The default value is <n>=15 seconds. A setting of <n>=255

causes the modem to disable carrier detection and presume

the carrier is always present.

1–255 015 0.1 s

Table 3-10: S registers (cont.)

Reg. Description Range Default Units

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 117 118

No comments

Velocity Edge GX440 Specifications Page 107