Velocity Edge GX440 Specifications download pdf (Page 106)

MP 700 Series GPS AT Command Reference

104 2130309

Status Registers

Some of these registers relate to the call progress timing at the

IWF (the interface between the GSM network and the PSTN)

with the PSTN connection. These are noted below using the

(Remote) tag.

Table 3-10: S registers

Reg. Description Range Default Units

0 Number of rings before answer (or accept/reject PDP

context activation request)

GSM mode When operating in GSM voice or CSD mode,

the S0 status register is used to set the number of rings before

automatically answering a call—<n> is a numeric value

between 0 and 255 representing the number of rings before

pickup. A value of <n>=0 deactivates auto-answering.

0–255 000 rings

(cont.)

GPRS mode When operating in GPRS packet mode, the

S0 status register can be used to set whether the modem

automatically accepts incoming PDP context activation

requests from the network.

• If <n>=0, the modem will not automatically accept a network

connection request.

• If <n>=1 or any other greater value, the modem will

automatically accept a connection request.

Note: ATS0=0 does not perform an automatic GPRS detach.

Inquiry ATS0? returns the current setting of the register.

0, 1 0 Boolean

3 Command line termination character (usually <CR>)

Sets the standard end-of-line character used to indicate the end

of an AT command. This character is also used as the carriage

return character for framing responses and result codes in

command state. The default and standard line termination

character is the carriage return <CR> (ASCII 13).

0–127 013 (CR) ASCII

4 Response formatting character (usually <LF>)

Sets the standard character sent by the modem to the host at

the end of a response or return code in command state. The

default and standard response-end character is the line feed

<LF> (ASCII 10).

0–127 010 (LF) ASCII

5 Command line editing character (usually <BS>)

Sets the standard character used to backspace when editing on

the command line. The default and standard response-end

character is the backspace <BS> (ASCII 8).

0–127 008 (BS) ASCII

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 117 118

Comments to this Manuals

No comments

Velocity Edge GX440 Specifications Page 106

Comments to this Manuals

Related products and manuals for PC/workstation barebones Velocity Edge GX440